Advanced Air Purification
Spring allergies can be unbearable without adequate protection from the billions of pollen spores that will enter your building. Fortunately air purity specialists have produced a whole house air sanitizer that combines four advanced technologies for maximum allergen eradication. National Energy Technologies is proud to be a factory distributer for the GT3000 and Duct Pure systems, possibly the most advanced air purification systems on the market. Incorporating photo catalytic oxidation technology, high level negative ionization, safe levels of ozone, and electrostatic filtration, the GT3000 reduces particles and inactivates microbes thus providing a cleaner, healthier environment for you and your building occupants. The Duct Pure creates Photo Catalytic Oxidation which will destroy VOC's, odor, bacteria, viruses and mold spores.
Using four advanced technologies, the GT3000 helps to eliminate odors, smoke, pollen, dust, bacteria, mold, pet dander, viruses, and much more. Pollution is eliminated in as little as 15 minutes, and the most difficult pollution in as few as 24 hours. Unlike other air purifiers that have only one or two ways of eliminating pollution, the GT3000 has four advanced technologies to destroy pollution from the air, embedded in walls, ceilings, floors, carpets, furniture, clothing, on counter tops and other surfaces. These technologies help to sanitize everything in the area and can reduce or eliminate all odors, including cigarette smoke, mildew, cooking odors, and more.
The Advanced Photo Catalytic Oxidation (PCO) Cell in the Duct Pure and GT3000 not only destroys biological contaminants traveling through the cell, but it produces purifying plasma which breaks down odors, mold, bacteria and viruses. Photo Catalytic Oxidation reactors have been proven to reduce dangerous pathogens by over 99% in 24 hours or less. This process is molecular disassociation, which doesn’t just cover up the source, it actually breaks the molecule down. The result at the end of the breakdown process is Carbon Dioxide and Water Vapor.
The GT3000 also generates Needlepoint Ionization, a continuous stream of millions of negative ions that circulate throughout the building. These ions charge particles of dust, smoke, dander, bacteria and viruses; causing them to attract other particles and clump together. As more and more particles come together, they become heavier, making them easier to pull into the building filter or just fall to the floor to be vacuumed up. Unlike HEPA filters that can only filter out particles of .5 microns or larger, the ionizer in the GT3000 can reduce ultra-fine particles, even nano-particles, that are much more dangerous than the larger particles you can see. This means your employees and customers breathe easier with fewer particles in the breathing space, less exposure to bacteria, mold and virus particles as well.
In the sanitization Mode the purification plate is activated to generate activated oxygen to assist in breaking down mold, bacteria, smoke and other biological contaminants which cause odors. By setting the purifier based upon the area to be treated, just the right amount of purification is produced to keep the space fresh and clean. For faster cleanup an “Away Mode” feature which has an auto-shutoff programmable timer allows for maximum output to be used when the room unoccupied. An advanced electrostatic filter is included with the GT3000 to help keep the purifier clean while at the same time filter out particles which clump together thanks to the needlepoint ionization. Unlike expensive HEPA filters, the electrostatic filter is washable and can be used over and over again.